In short: choose a boat trailer by the boat’s real weight – with engine, fuel, battery and gear – and leave at least a 15% margin in the payload. Measure the boat from the bow eye to the transom, not its overall length. A trailer with a gross weight over 750kg must have brakes. After salt water, rinse the trailer’s brakes, wheels and bearings with clean water.
A boat trailer carries the boat when it is at its heaviest: with the engine, fuel and gear on board. A trailer that is too small makes launching harder and towing dangerous. This guide explains how to choose a trailer by the boat’s weight, length and hull shape.
1. Work out the boat’s real weight
Manufacturers often give the boat’s dry weight. Add the engine, fuel (petrol weighs about 0.75kg per litre), battery, anchor, life jackets and other gear that stays in the boat. The trailer’s payload must be higher than that: boat trailer makers and dealers recommend a margin of at least 15%.
Example: a 450kg boat, a 110kg engine, 50 litres of petrol (about 38kg) and 40kg of gear add up to about 640kg. With a 15% margin you need a payload of at least 735kg. The payload of a 750kg trailer (504–571kg) is then too small, and a 64SLB 1200kg with a payload of 861kg fits.
2. Trailer length
Measure the boat from the bow eye (where the winch hook attaches) to the transom. The boat’s overall length often includes the engine or a swim platform, so it is not the right measure for choosing a trailer. Trailermate boat trailers have a winch post adjustable in length and height so that the boat sits correctly on the trailer.
| Model | Boat length | Gross weight | Payload | Brakes and axles |
|---|---|---|---|---|
| 53S jet ski trailer | jet ski or small boat up to ~5m | 750kg | 571kg | unbraked, 1 axle |
| 58S | up to ~5.8m | 750kg | 504kg | unbraked, 1 axle |
| 64SLB | up to ~6.4m | 1200 or 1400kg | 861 or 1061kg | braked, 1 axle |
| 69SLB | up to ~6.9m | 1600 or 1900kg | 1164 or 1464kg | braked, 1 axle |
| 78DLB | up to ~7.8m | 2820, 3000 or 3150kg | 2160–2490kg | braked, 2 axles |
All models and prices are under boat trailers. There is also the Randa launching trailer for boats over 10m, made for moving a boat at the launch site and for winter storage, not for road use.
3. Keel rollers and side supports
The boat’s weight must rest on the keel rollers; the side supports keep the boat upright and help guide it onto the trailer, but do not carry the weight. Trailermate boat trailers have adjustable keel rollers and steplessly adjustable side supports, and the larger models have rear side supports with gas springs. The 53S jet ski trailer has adjustable bunks under the craft. Set the keel rollers and side supports to your boat’s hull before the first launch.
Worn or broken rollers damage the hull. Spare keel rollers, side rollers and bow stops are in the shop.
4. Brakes, axles and licence
A trailer with a gross weight over 750kg must have brakes. The Trailermate boat trailers 64SLB, 69SLB and 78DLB are braked and have waterproof KNOTT hubs. The twin-axle 78DLB is made for boats up to ~7.8m and has rubber-suspension axles.
With a braked trailer, check what your car and licence allow: category B covers a combination with a gross weight up to 3500kg, B96 up to 4250kg, and a heavier one needs BE. Enter your car’s details in the licence calculator.
5. Width and projecting load
If the boat is wider than permitted for a vehicle, the transport is oversize and needs a special permit. If the boat or engine sticks out more than 1 metre behind the trailer, mark its furthest point with a projecting-load marker.
6. Launching and retrieving the boat
- Before the ramp, unplug bulb lights and let the bulbs cool for 10 minutes; with LED lights this is not needed (see trailer lights and plug).
- Reverse until the water reaches the tyres but not the wheel hubs – otherwise the wheel bearings can be damaged.
- Apply the parking brake before you get out of the car.
- Remove the tie-down straps, but keep the winch strap attached until the boat floats.
- Let the boat into the water carefully by winding the winch back.
When retrieving, pull the winch strap out to its full length, attach the hook to the bow eye and winch the boat on so that it rests on the keel rollers. Make sure the winch is locked. The winch is not for securing the load: strap the boat down at the front and the rear for the trip (see securing a load).
7. Care after salt water and in winter
After salt water, rinse the trailer with clean water, especially the brakes, wheels and bearings. Drum brakes hold water, so a hub flushing system is available for braked boat trailers to flush the brakes and hubs with a hose. For replacing bearings, see the hub, bearing and brake cable guide.
For the winter, put the trailer on stands if you can, so that the tyres do not carry the boat’s weight for months, and check the tyres and tyre pressure in spring. Also check the winch strap or cable and replace it if it is damaged.
Not sure which model fits your boat? Send us the boat’s dimensions and weight and request a quote.



